Browse all practice questions for the Communication and Navigation Systems Practice Test. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

Communication and Navigation Systems Practice Test course image
All questions

These questions are part of the practice quiz. Start practicing

  • In a link budget, which quantity represents the minimum detectable signal at the receiver?
  • Which statement about GPS time and UTC is true?
  • When operationally checking an autopilot system on the ground, after the aircraft's main power has been switched on, the autopilot should be engaged:
  • Which statement correctly describes Precise Point Positioning (PPP) relative to RTK?
  • How do carrier tracking and code tracking loops operate in GNSS receivers?
  • In general, the purpose of an aircraft transponder is to
  • An aircraft antenna installation must be grounded to which structure?
  • Where is the battery replacement date visually indicated on an ELT?
  • The VOR antenna is typically located on the exterior of a light aircraft in which position?
  • What is the main reason to secure coaxial cable along its length?
  • Which of the following is a loop sense antenna?
  • Which material is used as a gasket between the antenna mast and fuselage to seal against moisture?
  • (1) Use solder to attach bonding jumpers on radio equipment. (2) Radio equipment is bonded to the aircraft in order to provide a low-impedance ground and to minimize radio interference from static electrical charges. Regarding the above statements, which is true?
  • What is the difference between satellite ephemeris and almanac?
  • Which multiple-access scheme uses unique spreading codes to allow simultaneous users on a shared channel?
  • What is the role of a phase-locked loop in a receiver?
  • Static discharge wicks on aircraft serve what purpose?
  • If fewer satellites are visible or geometry is poor, Dilution of Precision (DOP) is:
  • What is the approximate drag load on an antenna with a frontal area of 0.125 square feet at 225 mph?
  • On modern large aircraft, which electronic device typically monitors flight parameters and performs autopilot functions?
  • In an autopilot system, which signal cancels or nullifies the input command to the ailerons?
  • Which device is commonly described as the sensing element providing attitude information to an autopilot system’s guidance?
  • An emergency locator transmitter (ELT) is normally activated by an inertial switch when subjected to a force of prescribed intensity and duration. It must activate when the force is applied along which axis?
  • Static dischargers help eliminate radio interference by dissipating static electricity into the atmosphere at what current levels?
  • The preferred location of a VOR antenna on light aircraft is on which part of the airplane?
  • Which antenna is typical for DME?
  • What is the primary purpose of a GNSS link budget equation?
  • Where should an aircraft antenna installation be grounded?
  • During inspection, what is the method to verify ELT operation?
  • What is the term for the yawing and rolling oscillation that a yaw damper system counters in swept-wing aircraft?
  • Real-Time Kinematic (RTK) achieves centimeter-level accuracy by:
  • Which statement correctly describes Galileo and BeiDou signal bands and the capability for dual-frequency operation?
  • How are INS and GNSS integrated in navigation systems?
  • DGPS correction delivery in GNSS is typically accomplished how?
  • Which items are typically included in a link budget?
  • After ADIF antenna installation, which procedure must be completed to ensure accurate function?
  • In GNSS, which statement best describes carrier-phase measurements?
  • Which action is correct during ground autopilot checks?
  • ADF system commonly uses which type of antennas?
  • Which component is primarily responsible for converting autopilot commands into mechanical movement of the aircraft’s control surfaces?
  • What principle describes the sensing device used in an autopilot system?
  • Real-Time Kinematic (RTK) achieves centimeter-level accuracy by:
  • Doublers in antenna installations are used to
  • How can the battery replacement date for an emergency locator transmitter (ELT) be verified?
  • Which item needs calibration after adding an automatic direction finding antenna?
  • What is RTCM used for in GNSS?
  • What is the primary purpose of an autopilot?
  • When installing coaxial cable, it should be secured firmly along its entire length at what interval?
  • In autopilot systems, which device is primarily responsible for converting operational commands into physical movement of the control surfaces?
  • What component is the sensing device in an electromechanical autopilot system?
  • In BPSK over AWGN, how does BER change with Eb/N0?
  • What is DME and how does it work?
  • The sensing device in an autopilot responds to which relationship?
  • Where is the preferred location of the ELT installed on an aircraft?
  • During an aircraft inspection, how may the operation of an installed ELT be verified?
  • Which condition triggers ELT battery replacement, aside from reading the replacement date?
  • What is the standard axis count for a fully integrated autopilot?
  • What is the function of a zenith tropospheric delay mapping function in GNSS processing?
  • Which of the following statements is true about forward avionics placement?
  • In a GNSS link budget, what does Lpath represent?
  • What is a Low-Noise Amplifier (LNA) and why is it critical?
  • In autopilot sensing, which description best describes the sensing element's operating principle?
  • In a post-install ELT test, what action should you perform?
  • What is channel coding and how do convolutional and turbo codes improve reliability?
  • Which statement best defines bandwidth in a communications channel?
  • When evaluating the installation of a rigid antenna on the vertical stabilizer, which issues should be considered?
  • Which autopilot component is associated with controlling aircraft pitch attitude?
  • If an antenna is blanked by the wing, what is the likely effect on signal reception?
  • In OFDM, how does the scheme cope with multipath environments?
  • A transponder responds to ground-based interrogations by
  • What is the far-field condition for antennas in terms of the largest dimension D and wavelength λ?
  • Which antenna is used for VOR and Localizer signals?
  • A typical GNSS receiver front-end architecture includes:
  • What does the 'P(Y)' designation indicate on the GPS L2 signal?
  • What clearance from the seat bottom is required when installing radio equipment under a seat?
  • Which signaling concept does GPS primarily use to allow multiple satellites to be received on the same frequency?
  • With respect to an aerial installation, where is the strongest signal generally found?
  • What is the role of a flight management computer?
  • When bending coaxial cable, the bend radius should be at least
  • To verify ELT operation during inspection, what sequence should be followed?
  • What are the typical mitigations for GPS jamming and spoofing?
  • Why are relativistic effects important for GPS satellite clocks?
  • Ionospheric delay in GNSS is mitigated by:
  • Which statement about spread-spectrum systems is true?
  • Which autopilot component applies torque to the control surfaces of an aircraft?
  • Which statement about NMEA 0183 sentence types is true?
  • Which factors influence Time to First Fix (TTFF) in a GNSS receiver?
  • In the landing configuration, GPWS typically monitors which of the following inputs?
  • How do dual-frequency GNSS receivers estimate ionospheric delay?
  • In GPWS described operation, which type of altitude measurement is used to determine height above the ground?
  • Which statement correctly relates antenna gain, directivity, and efficiency?
  • Why is GNSS reception challenging indoors and what techniques help?
  • How is a GNSS link budget expressed and what do the terms represent?
  • In aerodynamic terms, drag on a surface is proportional to which of the following (assuming area and Cd are constant)?
  • In which control element of an autopilot system is an attitude indicator?
  • What is NMEA 0183 used for in GNSS receivers?
  • Forward of the CG limit, the addition of avionics and associated antenna systems will affect which airplane characteristic?
  • The installation of an automatic direction finding antenna requires calibration of which part?
  • A fully integrated autopilot typically controls the aircraft about how many axes?
  • How should an antenna be fastened to satisfy proper installation?
  • Which statement accurately describes the signaling architecture difference between GLONASS and GPS?
  • Which statement best describes the role of bonding jumpers in radio installations?
  • Which device is typically used to supply attitude information required by the autopilot to maintain stable flight?
  • For BPSK over AWGN, which expression correctly describes the bit error rate as a function of Eb/N0?
  • For a given antenna, where is the strongest signal typically located?
  • What is Orthogonal Frequency Division Multiplexing (OFDM) and why is it used in modern digital communication?
  • What is the primary purpose of Receiver Autonomous Integrity Monitoring (RAIM) in GNSS?
  • Which statement correctly describes the difference between the GPS L1 C/A signal and the L2P(Y) signal?
  • What is Differential GPS (DGPS) and how does it improve accuracy?
  • Which issues are the primary concerns for a rigid antenna mounted on the vertical stabilizer?
  • Which system counteracts Dutch roll, a yawing and rolling oscillation common in swept-wing aircraft?
  • Bonding radio equipment to the aircraft provides a low-impedance ground and minimizes interference from static charges. Which of the following best describes this practice?
  • What is a dipole antenna?
  • VHF signals are commonly used in
  • Which component is an altitude encoder used with transponders?
  • In GNSS, Doppler measurements are used to determine:
  • What is the main reason for ensuring the DME antenna is not blanked by the wing during banked flight?
  • One antenna can be used for the radio range and standard broadcast bands in light aircraft because
  • What is the role of RF filters in a receiver front-end?
  • Which channel of an autopilot detects changes in pitch attitude of an aircraft?
  • Multipath in GNSS refers to:
  • Which statement correctly describes Precise Point Positioning (PPP) relative to RTK?
  • When mounting any antenna, what is the critical reason for securing it?
  • In RTK GNSS, why is a reference station used?
  • When must the ELT battery be replaced (excluding reading the replacement date)?
  • Under what condition is a U.S. resident NOT required to hold an FCC Restricted Radio Telephone Operator Permit to operate two-way aircraft VHF radio equipment?
  • A gasket or sealant is used between the antenna mast and fuselage skin to prevent the entry of
  • What is ILS and how does it help approach?
  • What is the main purpose of a servo in an autopilot system?
  • Which statement accurately describes GPS time and UTC with respect to leap seconds?
  • Satellite-Based Augmentation System (SBAS) provides which services?
  • Part of the ADF system used on aircraft includes
  • What is the effect of polarization mismatch on GNSS signal reception?
  • When fastening an antenna installation, what is the purpose?
  • For checking ELT function during maintenance, which procedure is appropriate?
  • Which property of PN sequences is most beneficial in spread-spectrum communications?
  • Dilution of Precision (DOP) is a metric of satellite geometry affecting position error. A lower DOP value indicates:
  • In Instrument Landing System, what does the localizer provide?
  • The autopilot's aileron input is nullified by which type of signal?
  • If an autopilot changes the aircraft’s attitude to correct an error and the control surfaces are returned to streamline by the time the aircraft has reached the correct position, what is the result?
  • If autopilot corrections are made and the aircraft stabilizes as the surfaces streamline during approach, what is the outcome?
  • When must the radio station license be displayed in an aircraft equipped with a two-way radio?
  • The ELT activation axis is along which axis of the aircraft?
  • After installing an automatic direction finding antenna, which component must be calibrated?
  • Dilution of Precision (DOP) is a measure of satellite geometry affecting position error. A lower DOP value indicates:
  • After installing an automatic direction finding antenna, which procedure must be completed to ensure accurate function?
  • Which component provides manual maneuverability of the aircraft while the autopilot is engaged?
  • What are RTK corrections and how are they delivered?
  • True or false: Bonding radio equipment to the aircraft reduces interference from static charges.
  • What is the correct fastening guideline for an installed antenna?
  • The elevator channel of an autopilot controls the aircraft about which axis of rotation?
  • What is Receiver Autonomous Integrity Monitoring (RAIM) and why is it important for GNSS integrity?
  • VHF signals are commonly used in aviation for which pair of functions?
  • Why is impedance matching important in RF systems?
  • What component protects installed radio equipment from damage due to jolts and vibration?
  • What is the reason one antenna can serve multiple bands in light aircraft?
  • Which modulation technique modulates the carrier phase?
  • Explain which polarization GNSS uses and why it matters.
  • What is the main decoding mechanism behind turbo codes?
  • Doublers are used when antennas are installed to
  • What is the purpose of the localizer in instrument landing guidance?
  • The approximate drag load on an antenna with a frontal area of 0.137 ft² installed on an aircraft at 275 mph is which value?
  • Which device is typically responsible for monitoring flight parameters and performing autopilot functions on modern large aircraft?
  • For an ELT, which method is used to verify the battery replacement date?
  • BeiDou's B1I and B2I signals belong to which GNSS system?
  • According to Shannon's capacity formula, what happens to channel capacity as bandwidth increases at fixed SNR?
  • What is a VOR and its principle in aviation navigation?
  • How is tropospheric delay modeled and mitigated?
  • Doppler measurements contribute to estimating:
  • In GNSS, which statement best describes carrier-phase measurements?
  • Which statement describes coherent demodulation?
  • What is the role of a Kalman filter in navigation systems?
  • Why fuse GNSS with INS for robust navigation?
  • The correct fastening method for an installed antenna ensures what structural consideration?
  • A DME antenna should be located in a position on the aircraft that will
  • When installing a DME antenna, it should be aligned with which part of the airplane?
  • The purpose of a glideslope system is to
  • What is the primary role of PN sequences in spread-spectrum systems?
  • An emergency locator transmitter (ELT) battery must be capable of furnishing power for signal transmission for at least how many hours?
  • The autopilot elevator channel affects which flight parameter most directly?
Subscribe

Get the latest from Examzify

You can unsubscribe at any time. Read our privacy policy